Back Housing

If your phone’s back housing is broken or scratched, do not hesitate and get a replacement. At Mobizona.lt you will find parts of various qualities: original, high quality and analog housings for Apple iPhone, Samsung Galaxy, Sony, Huawei, Honor, Nokia, OnePlus and Xiaomi and other phones. 

How to change back housing?

The replacement process is not complicated, but like any repair requires skill. There are two types of back housing: full back housing, which perform the function of a full body, and glass-like back covers, which are attached to the phone case with double-sided adhesive tape. 

Full back housing. Replacement can be a real challenge if the cell phone is similar to the iPhone 5, 6, 6S, 7, 7 Plus, as all the internal parts of the phone are attached to the back housing and must be moved to a new battery cover during replacement. This work can take as long as 1-3 hours. 

Back glass. Replacement is much simpler because such back covers are attached with double-sided adhesive tape, which is airtight. To remove it, heat the phone back housing to 70 ° C to reduce the adhesion of the adhesive tape. 

It is then best to use a narrow plastic tool (to avoid scratching the housing of the phone with a sharp object), insert it under the back cover and run it around the entire perimeter to detach the double-sided tape from the case. 

Be careful as there may be other parts of the phone under the cover and the tool should not go more than 0.5-1.0 cm deep under the cover, as the double-sided tape usually holds the cover only at the edges, over the entire perimeter. 

If you don’t have enough experience or equipment for such a delicate job, contact our customer service and we will guide you to a specific repair shop for required replacement service.

Suggestions

• If the back housing is broken, cover it with regular duct tape to prevent the back housing from breaking apart during disassembly. 
• Thoroughly remove any old adhesive residue before replacing the new back housing
• If you are replacing the back housing with a new original one, heat the back cover after installation and keep it pressed for 5-10 minutes to ensure maximum adhesion of the rear cover to the housing. 
• If you choose a high-quality or back housing analog, make sure you have the additional silicone glue, which you can also buy in our store, as double-sided tape adhesion can be poor on non-genuine covers.