Homepage
Your Cart

Huawei Mate 20 Pro Rear Back Housing Adhesive Tape

13-in-1 Screwdriver and Opening Tool Set – Y000 Tri-Wing, P2, P5 Pentalobe, Phillips 1.5 mm, Flat 2.0 mm for Phone and Tablet Repair
Hot
13-in-1 Screwdriver and Opening Tool Set – Y000 Tri-Wing, P2, P5 Pentalobe, Phillips 1.5 mm, Flat 2.0 mm for Phone and Tablet Repair
A 13-piece screwdriver and opening tool set designed for repairing phones, tablets, and small electronics.The kit includes the most commonly used scre..
5.80 €
Add to Cart
Add to Wish List Compare this Product
13-in-1 Screwdriver and Opening Tool Set – Y000 Tri-Wing, P2, P5 Pentalobe, Phillips 1.5 mm, Flat 2.0 mm for Phone and Tablet Repair
Hot
13-in-1 Screwdriver and Opening Tool Set – Y000 Tri-Wing, P2, P5 Pentalobe, Phillips 1.5 mm, Flat 2.0 mm for Phone and Tablet Repair
A 13-piece screwdriver and opening tool set designed for repairing phones, tablets, and small electronics.The kit includes the most commonly used scre..
5.80 €
Add to Cart
Add to Wish List Compare this Product
Huawei P30 Pro, Mate 20 Pro Battery (HB486486ECW)
Huawei P30 Pro, Mate 20 Pro Battery (HB486486ECW)
Huawei P30 Pro, Mate 20 Pro battery replacement HB486486ECW with a capacity of 4200mAh is one of the main components of a cell phones. If you have pro..
20.49 € up to 28.48 €
Add to Wish List Compare this Product
Huawei Mate 20 Pro Rear Back Housing Adhesive Tape
  • Stock: In Stock
(0 reviews) Add Review
8.35 €
Ex Tax: 6.90 €
Code: 65667
Add to Cart
Ask
Add to Wish List Compare this Product

Huawei Mate 20 Pro Rear Back Housing Adhesive Tape

Huawei Mate 20 Pro double-sided adhesive back cover (battery) sticker for attaching the back cover to the frame. The double-sided sticker on the back cover is waterproof, but water can still penetrate the device if it has not been 100% hermetically sealed. Before gluing this sticker, it is important to remove the remnants of the old sticker cleanly and without dust to ensure a strong adhesion. Before gluing this sticker, it is important to remove the remnants of the old sticker cleanly and without dust to ensure a strong adhesion. It is recommended to keep the sticker firmly pressed for at least 30-60 minutes after complete assembly of the device with special clamps.

Add Review

Note: HTML is not translated!
Bad Good