Homepage
Your Cart

Samsung Galaxy A7 (2018) Rear Back Housing Adhesive Tape

13-in-1 Screwdriver and Opening Tool Set – Y000 Tri-Wing, P2, P5 Pentalobe, Phillips 1.5 mm, Flat 2.0 mm for Phone and Tablet Repair
Hot
13-in-1 Screwdriver and Opening Tool Set – Y000 Tri-Wing, P2, P5 Pentalobe, Phillips 1.5 mm, Flat 2.0 mm for Phone and Tablet Repair
A 13-piece screwdriver and opening tool set designed for repairing phones, tablets, and small electronics.The kit includes the most commonly used scre..
5.80€
Ex Tax:4.79€
Add to Cart
Add to Wish List Compare this Product
Samsung Galaxy A7 (2018) Screen
Samsung Galaxy A7 (2018) Screen
Samsung Galaxy A7 (2018) (SM-A750F) screen is designed to replace an old screen assembly that no longer responds to control, has dead screen dots or h..
51.95€
Ex Tax:42.93€
Add to Cart
Add to Wish List Compare this Product
Samsung Galaxy A7 (2018) Charging Port, Headphone Jack and Microphone (PCB Board)
Samsung Galaxy A7 (2018) Charging Port, Headphone Jack and Microphone (PCB Board)
Samsung Galaxy A7 (2018) (SM-A750F) PCB board which consists of a charge connector (charging port/socket), headphone jack and a microphone, will help ..
11.98€
Ex Tax:9.90€
Add to Cart
Add to Wish List Compare this Product
Samsung Galaxy A7 (2018) Back Housing
Samsung Galaxy A7 (2018) Back Housing
Samsung Galaxy A7 (2018) (SM-A750F) back housing is designed to replace your scratched, broken, bent, or otherwise damaged back housing. If the back h..
12.71€
Ex Tax:10.50€
Add to Cart
Add to Wish List Compare this Product
Samsung Galaxy A7 (2018) Rear Back Housing Adhesive Tape
  • Stock: In Stock
(0 reviews) Add Review
10.89€
Ex Tax: 9.00€
Code: 78385
Add to Cart
Ask
Add to Wish List Compare this Product

Samsung Galaxy A7 (2018) Rear Back Housing Adhesive Tape

Samsung Galaxy A7 (2018) (SM-A750F) double-sided adhesive back cover (battery) sticker for attaching the back cover to the frame. The double-sided sticker on the back cover is waterproof, but water can still penetrate the device if it has not been 100% hermetically sealed. Before gluing this sticker, it is important to remove the remnants of the old sticker cleanly and without dust to ensure a strong adhesion. Before gluing this sticker, it is important to remove the remnants of the old sticker cleanly and without dust to ensure a strong adhesion. It is recommended to keep the sticker firmly pressed for at least 30-60 minutes after complete assembly of the device with special clamps.

Add Review

Note: HTML is not translated!
Bad Good