Homepage
Your Cart

Samsung Galaxy Note 10 Rear Back Housing Adhesive Tape

Samsung Galaxy Note 10 Rear Back Housing Adhesive Tape
13-in-1 Screwdriver and Opening Tool Set – Y000 Tri-Wing, P2, P5 Pentalobe, Phillips 1.5 mm, Flat 2.0 mm for Phone and Tablet Repair
Hot
13-in-1 Screwdriver and Opening Tool Set – Y000 Tri-Wing, P2, P5 Pentalobe, Phillips 1.5 mm, Flat 2.0 mm for Phone and Tablet Repair
A 13-piece screwdriver and opening tool set designed for repairing phones, tablets, and small electronics.The kit includes the most commonly used scre..
5.80 €
Add to Cart
Add to Wish List Compare this Product
Samsung Galaxy A71 Charging Port, Headphone Jack and Microphone (PCB Board)
Samsung Galaxy A71 Charging Port, Headphone Jack and Microphone (PCB Board)
Samsung Galaxy A71 (SM-A715F) PCB board which consists of a charge connector (charging port/socket), headphone jack and a microphone, will help solve ..
17.41 – 20.57 €
Choose variant
Add to Wish List Compare this Product
Samsung Galaxy Note 10 Charging Port and Microphone (PCB Board)
Samsung Galaxy Note 10 Charging Port and Microphone (PCB Board)
Samsung Galaxy Note 10 (SM-N970F) PCB board which consists of a charge connector (charging port/socket) and a microphone, will help solve problems wit..
22.99 – 28.70 €
Choose variant
Add to Wish List Compare this Product
Samsung Galaxy Note 10 Battery (EB-BN970ABU)
Samsung Galaxy Note 10 Battery (EB-BN970ABU)
Samsung Galaxy Note 10 (SM-N970F) battery replacement EB-BN970ABU with a capacity of 3500mAh is one of the main components of a cell phones. If you ha..
9.58 – 36.43 €
Choose variant
Add to Wish List Compare this Product
Samsung Galaxy Note 10 Rear Back Housing Adhesive Tape
  • Stock: In Stock
(0 reviews) Add Review
2.13 €
Ex Tax: 1.76 €
Code: 68250
Add to Cart
Ask
Add to Wish List Compare this Product

Samsung Galaxy Note 10 Rear Back Housing Adhesive Tape

Samsung Galaxy Note 10 (SM-N970F) double-sided adhesive back cover (battery) sticker for attaching the back cover to the frame. The double-sided sticker on the back cover is waterproof, but water can still penetrate the device if it has not been 100% hermetically sealed. Before gluing this sticker, it is important to remove the remnants of the old sticker cleanly and without dust to ensure a strong adhesion. Before gluing this sticker, it is important to remove the remnants of the old sticker cleanly and without dust to ensure a strong adhesion. It is recommended to keep the sticker firmly pressed for at least 30-60 minutes after complete assembly of the device with special clamps.

Add Review

Note: HTML is not translated!
Bad Good