Samsung Galaxy S23+ Tempered Glass 5D UV
5D UV Nano Optics Tempered Glass that fully covers the entire phone screen is the next generation screen protection solution with built-in liquid dispersion technology that no other lens currently has. Supplied with specially formulated glass glue, which automatically expands when the glass is applied on the screen, without any air bubbles! After the glue completely covered the screen under the protective glass, it must be cured with the LED ultraviolet (UV) lamp. Due to the UV light emitted by the LED lamp, the glue cures completely within 1-3 minutes. After the tempered glass will become much stronger than any previously tested 2D, 2.5D, 3D, 5D or other tempered glass. This tempered glass is 0.33mm thin and has 9H level hardness, delivering 99.9% HD resolution without any change in quality or color. You do not need to take any extra steps to remove the glass, simply remove the tempered glass from the screen and wipe away any glue that has left with a cloth or a wipe.
UV lamp
It is possible to purchase this tempered glass with UV lamp or without UV lamp, if you already have one.
Features and Benefits
- 99,9% HD transparency
- 9H level hardness glass
- Coating that reduces the appearance of fingerprints
- Non-reflective coating
- Suitable for use with many protective cases
5D UV application on the phone
It is very important that any cavities, that could be penetrated by the tempered glass glue, are covered with adhesive tape or otherwise insulated before gluing the glass so that the glue does not get into any cavities (e.g. speaker, on / off button, volume buttons, headphone jack, charging jack, etc.). If you do not do this and the glue accidentally enters any of the aforementioned cavities and the UV LED lamp accidentally dries it, you may need to take your phone to a service center to remove the glue from the phone.
1. Wipe the screen clean with a damp cloth provided in the package.
2. Then dry the wet surface with a dry cloth.
3. If you notice any dust left on the screen, you can remove it with a blue anti-static adhesive film that collects the left dust from the screen.
4. Take the glue bottle and apply the glue in the middle of the screen; glue's run-out stream is controlled by the regulator on the bottle (do not pour all glue at once as glue may need to be applied to the sides of the glass where the glue may not have spread completely).
5. Remove the protective film from the tempered glass and place it on the phone screen. Always wait for the glue to spread completely across the tempered glass itself (never press the tempered glass before glue completely spreads across the screen, as you can form air bubbles that will no be possible to be removed). If it has happened that the glue has not spread itself all the way through the tempered glass within 2-8 minutes, carefully fill in the following areas with the remaining glue.
6. When the glue has spread all over the screen, cure the glue with LED UV lamp (if any air bubbles will appear, do not try to remove them by pressing the screen as you can do more bubbles or move the glass from its original position).
7 .Once the glue has dried and attached to the screen, wipe away any excess glue from the phone and take off any protective strips that covered all the cavities where the glue could run in.
Package contains
- Samsung Galaxy S23+ (SM-S916B) 5D UV Nano Optics curved tempered glass
- Special glue
- Phone screen cleaning wipes
